Metrolane Roof Rack — Installation & Safety Manual

Metrolane Roof Rack — Installation & Safety Manual

1. Purpose

Provide controlled user-facing guidance for safe installation, inspection and support of the Metrolane roof rack represented by ERP item ITM-FG-RACK.

2. Product identification and intended use

ITM-FG-RACK — Metrolane roof rack, assembled is an active sellable Metrolane item. This manual provides general installation and care guidance. Vehicle-specific fitment data is governed by the applicable approved fitment information.

3. Safety principles

Use the rack only for its intended vehicle-accessory purpose and only when the mounting points and components are undamaged. Do not use visibly cracked, bent, loose or severely corroded parts. Stop use after an impact or other event that may have affected the rack until the assembly has been inspected. Never substitute unapproved hardware merely to complete an installation.

4. Installation and use

1. Confirm that the product and components match the intended installation and that no part shows shipping or handling damage.
2. Follow the approved mounting sequence for the applicable fitment; keep mating surfaces clean and correctly seated.
3. Use only compatible mounting components and verify that clamps/crossbars seat evenly.
4. Tighten and secure fasteners using the approved fitment instruction applicable to the installation; use the approved torque or fastening value specified for the applicable fitment.
5. Recheck the assembly for movement, interference and visible misalignment before carrying load.
6. Keep the installation evidence or sales/support reference needed for later service.

5. Inspection before use

Before use, inspect clamps, crossbars, coating/finish, fasteners and mounting contact points. Any fracture, significant deformation, loose connection or coating failure requiring support attention should be recorded rather than concealed.

6. Care and maintenance

Keep the rack clean, avoid conditions that promote avoidable corrosion, and inspect after unusual impact or service. Replace or service parts only through approved product/support processes.

7. Troubleshooting and support

For a product fault, damage, missing part or warranty question, contact Metrolane Support with available purchase, product and serial/part evidence. Warranty eligibility is decided under the applicable warranty policy, not by this manual.

8. Records

Retain product identity, order/receipt where available, installation/support evidence and any warranty or replacement records.

Fitment verification

Before installation, confirm that the product identity and the intended application are appropriate for the vehicle or installation context. Where vehicle-specific fitment data, torque values or other technical parameters are required, use the applicable approved fitment information rather than estimating a value from this general manual.

Post-installation checks

After installation, verify that components are seated correctly, fasteners and interfaces are secure according to the applicable approved instruction, and the assembly does not interfere with vehicle operation. Recheck the installation after initial use if the applicable service instruction requires it. Any looseness, deformation, damage or abnormal movement should be investigated before continued use.

Service, care and records

Keep the product clean enough to permit visual inspection and protect it from avoidable damage. Replace damaged components through the normal support or service process rather than modifying a safety-relevant component informally. Where a service, warranty or support case is raised, preserve product identity and the evidence needed to relate the issue to the relevant transaction.

Document control

This manual provides general controlled guidance for the identified product. It remains effective until replaced by a later published version. Product-specific bulletins, approved fitment instructions or other more specific controlled information take precedence for the condition they address.